Soffit, fascia and gutter work in Pompano Beach runs about $28 to $52 a linear foot depending on what has to come off first, and it is almost always a roof problem wearing a disguise. Fascia rots because water got behind the drip edge. Soffit sags because the fascia it hangs off has gone soft. Fixing the trim without fixing the edge detail means doing it again in four years.
Soffit is structural in a hurricane zone, which surprises people
A soffit is a pressure boundary, not decoration. Wind driving into the eave lifts the panel out of its channel, and once the soffit is gone the attic pressurises from underneath while the roof is being lifted from above. That combination is how roofs leave houses. Broward's code treats panel span, clip spacing and fastening as things to be got right, and the difference between a soffit that stays and one that does not is usually a few extra screws and a shorter unsupported span. After a storm, blown-out soffit is one of the most common damage patterns in this county, and it is often the only visible evidence that the attic took a pressure event.
Vented aluminium is the default here. Vinyl distorts in the heat, chalks, and goes brittle enough to shatter under wind-borne debris, and the cost difference across a typical house is small enough that it should not decide anything. Fascia goes back as treated timber where it is painted or PVC where you would rather never paint again, capped in aluminium coil stock on most jobs.
| Item | Price | Notes |
|---|---|---|
| Vented aluminium soffit | $16 to $28 per linear foot | Panel span drives the price more than the length |
| Fascia, treated timber, capped | $14 to $24 per linear foot | Add for rotten sub-fascia found behind it |
| Fascia, PVC | $20 to $34 per linear foot | No repainting, worth it on a two storey |
| Seamless aluminium gutter, 6 inch | $11 to $18 per linear foot | Rolled on site, colour matched |
| Downspout, 3 by 4 inch | $85 to $160 each | Sized to the roof area feeding it |
| Sub-fascia replacement | $18 to $32 per linear foot | Only found once the fascia comes off |
That last row is the one that moves. Sub-fascia is the framing member behind the visible board, and on a house where the drip edge has been leaking for years it is frequently gone. It cannot be seen from the ground and it cannot be priced honestly until the fascia is off, so it belongs in a quote as a rate rather than as a surprise.
Why is five inch gutter not enough here?
Five inch gutter cannot carry a Broward downpour off a large roof, and the overflow always goes over the front edge and straight onto the fascia. South Florida rainfall arrives at intensities that most gutter sizing charts were not written for, and the practical result is that six inch gutter with 3 by 4 inch downspouts is the sensible default on anything with a significant roof area. It costs a few hundred dollars more across a house and it prevents the exact failure that rots the trim you just paid to replace.
Do I need soffit vents?
Almost certainly, unless the attic is sealed and conditioned. Intake at the soffit and exhaust at the ridge is what stops a Broward attic reaching temperatures that cook the shingles from beneath and shorten a roof by years. Houses with a vented ridge and no soffit intake are the worst of both worlds, because the ridge simply pulls conditioned air out of the house. Adding vented soffit during a re-roof is cheap and it is one of the few upgrades that pays for itself in shingle life alone.
This work usually happens alongside a re-roof, since the drip edge and the fascia are the same detail approached from two sides. If the trim is failing and the roof is not, that is a repair conversation. Ring (954) 697-4046.
Where we work
Same crew, same specification, across the twelve towns inside a comfortable drive of the yard.
- Deerfield Beach and the streets around it
- soffit and fascia repair in Lighthouse Point
- Coconut Creek soffit and fascia repair
- soffit and fascia repair for Margate properties
- Coral Springs and the streets around it
- soffit and fascia repair in Fort Lauderdale
- Oakland Park soffit and fascia repair
- soffit and fascia repair for Wilton Manors properties
- Lauderdale-by-the-Sea and the streets around it
- soffit and fascia repair in Hillsboro Beach
- Parkland soffit and fascia repair
- soffit and fascia repair for Boca Raton properties
Drive times run from about eight minutes to Lighthouse Point out to twenty-five for Parkland. Anything further than that and you are better served by somebody based closer, and we will usually say so. Full list on the service areas page.
Questions Pompano Beach homeowners actually ask
Why did my soffit blow out in a storm?
Because a soffit is a pressure boundary, not just trim. Wind gets under the eave, lifts the panel out of the channel and then the attic pressurises, which is how roofs come off from the inside. Properly clipped and screwed soffit at the correct panel span is genuinely structural in a hurricane zone.
Aluminium or vinyl soffit?
Aluminium, here. Vinyl distorts in the heat, chalks, and gets brittle enough to shatter in wind-borne debris. The cost difference over a typical house is small enough not to be the deciding factor.
Do you do gutters on their own?
Yes, seamless aluminium, rolled on site. Six inch is the default on anything with a large roof area because five inch simply cannot carry a Broward downpour, and the overflow always finds the fascia.
Soffit panels sagging or fascia going soft?
Nine times out of ten the roof edge is the cause and the trim is the symptom. Worth catching before the next season rather than after it.
- 5-Star Rated
- Licensed & Insured
- Written, Itemised Quotes
Call before 4pm and a person picks up, not an answering service. Same-day callback on every voicemail, seven days a week.