Roofing in Coral Springs, FL

Coral Springs is the only city in our service area that charges a flat fee for a roofing permit instead of a percentage of the job. A sloped re-roof costs $463 whatever the roof is worth. A flat re-roof is $385. A roof repair of two squares or under is $187, and a roof with both sloped and flat sections is $861. Those numbers come straight from the city's published fee schedule and they change the arithmetic on a large tile job substantially.

Coral Springs roofing permit fees against the percentage model used in Pompano Beach, August 2026. Coral Springs figures from the city's published Fee Schedule and User Fees; Pompano Beach from its schedule updated 10 February 2026. Coral Springs adds an education and technology fee of $0.63 per $1,000 of estimated cost, plus a $100 residential submittal deposit credited against the permit.

Job	Coral Springs	Pompano Beach at 2.75 percent	Difference
Roof repair, 2 squares or under	$187 flat	$75 minimum	Pompano cheaper
$12,000 sloped shingle re-roof	$463 flat plus about $8	$330	Pompano cheaper
$20,000 sloped re-roof	$463 flat plus about $13	$550	Coral Springs cheaper
$35,000 tile re-roof	$463 flat plus about $22	$962.50	Coral Springs cheaper by roughly $477
Sloped and flat on one roof	$861 flat	Scale applies to total value	Depends on job size

The crossover sits at about a $17,000 job. Below that the percentage city is cheaper, above it the flat-fee city is, and on a big Heron Bay tile roof the gap runs to several hundred dollars. Worth knowing before you accept somebody's estimate of "permits, roughly a thousand".

What kind of roofs does Coral Springs have?

A very large planned city built mostly between 1970 and 1998, which gives it an unusually uniform roofing profile. Ramblewood and the older eastern sections off University Drive are 1970s shingle and early tile. Eagle Trace, Heron Bay and the northern communities are 1990s concrete tile on good decks. The practical consequence is that almost the entire city hit its first underlayment renewal in the last fifteen years, and a lot of it is now on a second-generation roof that is itself approaching twenty.

Deck condition is generally better here than anywhere else we work. Plywood sheathing throughout, installed under codes that were already tightening, so the deck replacement line that dominates a quote on 1950s stock further south is usually a footnote on a Coral Springs one. That makes quotes here more predictable and it makes a percentage-based permit fee feel less arbitrary, since the declared value is closer to the final number.

Is tile or shingle the right call in Coral Springs?

Tile, on most of the newer communities, because the elevations were designed for it and the associations frequently require it. Where a 1970s house already has shingle, replacing like for like with architectural shingle is usually the sensible economic answer. The inland location also means metal roofing can use Galvalume-coated steel rather than aluminium, which saves several thousand dollars against the same panel installed on the coast.

Do you actually cover Coral Springs, or is it a stretch?

Twenty-two minutes northwest, which is a real drive but a routine one. It is the second furthest town on our list and we would rather say plainly that on a small repair the travel is a bigger share of the job than it would be in Lighthouse Point. For a re-roof it makes no difference at all.

Also covered nearby: Parkland roofing, roofing in Margate and roofing for Coconut Creek properties. Ring (954) 697-4046.